Cisco 7606-S V01 Configuration With Two 2700 W Dc Power Supplies - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Cisco 7606-S DC Power Supply Configurations
The Cisco 7606-S router accepts two DC power supplies:
•
•
You can configure the DC power supplies in the Cisco 7606-S router as follows:
•
•
•
To configure the Cisco7606-S V01 and the Cisco7606-V V02 chassis to use the 2700 W DC-input power
supply and the 4500 W DC-input power supply, you must use the booster bracket (Part Number
800-31261-01) and the slim bracket (Part Number 700- 26979-01).
The PID for the slim bracket is KIT-MNTG-4500W06S= .
The PID for booster bracket is KIT-MNTG-2700W06S=.
Identifying Chassis Version in the Supported Line Card
You can use either of the following methods to identify the chassis version in the supported router:
•
•
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing.
Cisco 7606-S V01 Configuration with Two 2700 W DC Power
Supplies
This chassis uses booster bracket (Part Number 700-23386-01) to support the power supplies. You do
not have to change anything.
OL-4503-26
2700 W DC-input power supply
4500 W DC-input power supply
2700 W DC-input power supplies in both shelves.
4500 W DC-input power supplies in both shelves.
A 2700 W DC-input power supply in the upper shelf and a 4500 W DC-input power supply in the
lower shelf.
Product Identification Label on the router: - Displays the labels of all the supported chassis. For
example, the PID label Cisco7606-S V01 specifies that the chassis version is 01.
Show inventory command in the command line interface: - Displays the version ID of all the
supported chassis.
A P P E N D I X
Cisco 7600 Series Router Installation Guide
E
E-1