Appendix E
Cisco 7606-S DC Power Supply Configurations
Figure E-2
Cisco 7606-S V01 Configuration with a 2700 W DC Power Supply
and a 4500 W DC Power Supply
This configuration requires you to remove the booster brackets (Part Number 700-23386-01) and replace
them with the slim brackets (Part Number 700- 26979-01) . To do this, proceed as follows:
Remove the power supplies as described in
Step 1
When you are using a PWR-2700-DC and a PWR-4500-DC, you must install the PWR-4500-DC supply
Note
in the lower slot.
Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
Step 2
the top slot and remove the bracket. See
Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
Step 3
the lower slot and remove the bracket. See
Step 4
Use the screws (Part Number 48-2030-01) removed in Step 1 to install the slim bracket (Part Number
700-26979-01) at the top slot. See
Step 5
At the top slot, use three screws (Part Number 48-2454-01) to install the booster bracket (Part Number
800-31261-01) . See
Install the 2700 W DC power supply in the top slot as described in
Step 6
Supply in a Cisco 7606-S Router, page
Install the 4500 W DC in the lower shelves as described in
Step 7
a Cisco 7606-S Router, page
OL-4503-26
Cisco 7606-S V01 Configuration with a 2700 W DC Power Supply and a 4500 W DC Power Supply
Installing Slim Brackets
C is co 76
00
Se rie s
Figure
Figure
Figure
E-2.
Figure
E-3.
5-57.
5-61.
Removing a DC-Input Power Supply, page
E-1.
E-1.
Installing a PWR-2700-DC Power
Installing a PWR-4500-DC Power Supply in
Cisco 7600 Series Router Installation Guide
5-9.
E-3