Cisco 7606-S V02 Configuration With A 2700 W Dc Power Supply And A 4500 W Dc Power Supply - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Appendix E Cisco 7606-S DC Power Supply Configurations
Install the 4500 W DC in the lower slot as described in
Step 7
Cisco 7606-S Router, page
Figure E-4
Cisco 7606-S V02 Configuration with a 2700 W DC Power Supply
and a 4500 W DC Power Supply
This configuration requires you to remove the lower booster bracket (Part Number 800-31261-01).
Remove the PWR-2700-DC power supply from the lower slot as described in
Step 1
Power Supply from a Cisco 7606-S Router, page
When you are using a PWR-2700-DC and a PWR-4500-DC, you must install the PWR-4500-DC supply
Note
in the lower slot.
Remove three screws (Part Number 48-2454-01) securing the booster bracket (Part Number
Step 2
800-31261-01) at the bottom slot See.
Push the booster bracket (Part Number 800-31261-01) backward and then lift and remove it from the
Step 3
chassis.
Step 4 Install the 4500 W DC in the lower slot as described in
Cisco 7606-S Router, page
OL-4503-26

Cisco 7606-S V02 Configuration with a 2700 W DC Power Supply and a 4500 W DC Power Supply

5-61.
Removing Booster Brackets
C is co 76
00
Se rie s
Figure
5-61.
Installing a PWR-4500-DC Power Supply in a
5-19.
E-4.
Installing a PWR-4500-DC Power Supply in a
Cisco 7600 Series Router Installation Guide
Removing PWR-2700-DC
E-5