Unpacking The Router; Unpacking The Cisco Asr 9006 Router - Cisco ASR 9000 Series Installation Manual

Unpacking and Installing the Chassis
• Minimum of 10 slotted binderhead screws (usually provided with the rack) to secure the chassis to the
• 11/16-inch (17.46-mm) wrench (for chassis hold-down bolts and pallet hold-down bracket bolts)
• 3/4-inch (19-mm) socket and ratchet wrench

Unpacking the Router

The following instructions describe how to unpack the Cisco ASR 9000 Series Router from its shipping
container.

Unpacking the Cisco ASR 9006 Router

Follow these steps to unpack the Cisco ASR 9006 Router from its shipping container (see the figure below).
Procedure
Step 1 Cut the straps that secure the cardboard shipping container to the pallet.
Step 2
Remove the cardboard shipping container.
Step 3 Remove the packaging material (see the figure below).
a) Remove the foam packaging material from the top of the router.
b) Remove all screws that secure the four hold-down brackets to the router chassis. The forward hold-down
brackets are secured to the router mounting brackets by two screws. The rear hold-down brackets are
secured to the chassis by four screws.
c) Remove two bolts per hold-down bracket that secure the brackets to the pallet.
mounting flanges (also called rails ) in the rack. Five screws should be installed on each side of the
chassis.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Unpacking the Router
57