A P P E N D I X E Cisco 7606-S Dc Power Supply Configurations; Cisco 7606-S V01 Configuration With Two 4500 W Dc Power Supplies - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Cisco 7606-S V01 Configuration with Two 4500 W DC Power Supplies

Cisco 7606-S V01 Configuration with Two 4500 W DC Power
Supplies
This configuration requires you to remove the old booster brackets (Part Number 700-23386-01 ) and
Note
replace them with the slim brackets (Part Number 700- 26979-01). To do this, proceed as follows:
Remove the power supplies as described in
Step 1
7606-S Router, page
Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
Step 2
the top slot and remove the bracket. See
Remove the two screws (Part Number 48-2030-01) securing the bracket (Part Number 700-23386-01) at
Step 3
the lower slot and remove the bracket. See
Step 4 Use the screws (Part Number 48-2030-01) removed in Step 1 to install the slim bracket (Part Number
700-26979-01) at the top slot. See
Step 5 Use the screws (Part Number 48-2030-01) removed in Step 2 to install the slim bracket (Part Number
700-26979-01) at the bottom slot. See
Install the 4500 W DC in the upper and lower shelves as described in
Step 6
Supply in a Cisco 7606-S Router, page
Figure E-1
Cisco 7600 Series Router Installation Guide
E-2
5-19.
Figure
Figure
Figure E-2.
Figure
5-61.
Removing Fat Brackets
C is co 76
00
Se rie s
Appendix E Cisco 7606-S DC Power Supply Configurations
Removing PWR-2700-DC Power Supply from a Cisco
E-1.
E-1.
E-2.
Installing a PWR-4500-DC Power
OL-4503-26