Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 278

Cisco 7600 Series Router Power Supplies
Table A-9 Power Supply Specifications (continued)
Item
Output holdup time
2700 W DC-input Power Supply
Power supply output capacity
System power dissipation
DC-input voltage
DC-input current
Power supply output
DC input terminal block
Output holdup time
Ground Nut
Washer
Lugs required
Maximum torque
3000 W AC-input Power Supply
AC-input type
AC-input voltage rating
AC-input current rating
Power supply output capacity
AC-input frequency
Power supply output
KVA rating
Output holdup time
4000 W AC-input Power Supply
AC-input type
Cisco 7600 Series Router Installation Guide
A-12
Specification
20 ms minimum
Specification
2700W with two inputs active; 1350 W with one input
active.
3500W (total input power).
-48VDC nominal @ 37A in North America (operating
•
range: -40.5VDC to -56VDC)
-60VDC nominal @ 29A for International (operating
•
range: -55VDC to -72VDC).
40A per each DC input @ -48VDC input voltage (total two
inputs)
+1.5V @ 15A, +3.3V @ 5.0A, +50V @ 27.49A (one
•
DC input)
+1.5V @ 15A, +3.3V @ 5.0A, +50V @ 55.61A (Two
•
DC input)
Accepts 4 AWG copper conductors. Actual size of the wire
needed is determined by the installer or local electrician.
8 ms
1/4 inch x 20
1/4 inch split type
Industry Standard 2-hole compression lug with holes
on5/8- inch centers.
36 inch-lb
Specification
Autoranging input with power factor correction
100 to 120 VAC, 200 to 240 VAC (±10% for full range)
16 A @ 200 VAC (3000 W output)
•
16 A @ 100 VAC (1400 W output)
•
1400 W maximum (100–120 VAC)
•
3000 W maximum (200–240 VAC)
•
50/60 Hz (nominal) (±3% for full range)
1400 W maximum (100–120 VAC)
•
3000 W maximum (200–240 VAC)
•
3.6 KVA (high-line operation)
20 ms minimum
Specification
High-line input with power factor corrector, 30A
single-phase circuit
Appendix A Technical Specifications
1
(PFC)
OL-4503-26