Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 234

Removing and Replacing the Power Supply
Figure 5-100
Input power
Power leads
attached to
terminal block
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
b. From the left side of the power supply, connect each of the DC-input wires to the terminal block
(Figure 5-97
Note
Wire for 2800 W (right side of power supply bay) as follows:
Step 9
a. From the right side of the power supply, connect the ground wire to the ground
Cisco 7600 Series Router Installation Guide
5-106
DC-Input Wire Connections for 6000-W DC-Input Power Supply for Left Side of Power
Bay
module
Power
CI SC O SY
ST EM S, IN
C
switch
Captive
installation
screw
and Figure 5-100) in this order:
Negative (-)
Positive (+)
When you tighten the terminal nuts, make sure they are snug. Do not over tighten them.
Recommended torque strength is 20 inch-pounds. Over tightening the terminal nuts can
break the terminal block (Maximum torque: 36 inch-pounds).
Chapter 5
Terminal
block cover
1
2
3
IN PU T
4
OK
FA N
OU TP UT
OK
FA IL
( ) Ground
Removal and Replacement Procedures
(Figure 5-101).
OL-4503-26