Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 96

Installing the Chassis Brackets
Remove the screws that secure the brackets to the chassis. (See
Step 1
router for 19" racks,
brackets on Cisco 7604 router for 19" racks,
Figure 3-7
router, Cisco 7609-S router, and Cisco 7613 router for 19" racks).
Note
Note
Note
Figure 3-3
Cisco 7600 Series Router Installation Guide
3-6
Figure 3-4 for brackets on Cisco 7603-S router for 19" racks,
for brackets on Cisco 7606-S router for 19" racks and
Figure 3-8 shows the Cisco 7609 router and the Cisco 7609-S router. For 19" brackets, the
procedure is the same for the Cisco 7609 router, 7609-S router, and Cisco 7613 Router.
The Cisco 7609-S router chassis supports four-post 23" rack-mounting; it does not support a
single two-post (Telco) center flange rack-mount. You can accomplish a four-post frame mount
by using two by two-post(Telco) racks placed back to back or by using a four-post enclosed rack.
The Cisco 7609-S router is shipped with 19" racks. If you are installing the Cisco 7609-S router
into a 23" rack, use adapter plates (from Hendry or Newton) to reduce the 23" rack side to side
mounting screw pattern back down to a 19" rack dimension. Use the vendor-supplied
documentation to attach two of the adaptor plates to the 23" rack.
Brackets on Cisco 7603 Router
WS-X6K -SUP2-2 GE
CONSOLE
PORT
CONSOLE MODE
SUPERV ISOR2
PCMCIA
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
Chapter 3
Figure 3-6 for brackets on Cisco 7606 router for 19" racks,
Switch
Load
100%
PORT 1
PORT 2
EJECT
1%
Installing the Cisco 7600 Series Router
Figure 3-3 for brackets on Cisco 7603
Figure 3-5
Figure 3-8 for brackets on Cisco 7609
for
OL-4503-26