Setting The Configuration Register While Running Cisco Ios - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Setting the Configuration Register While Running Cisco IOS

If the prompt is "rommon1", the confreg command displays the virtual configuration register currently
in effect. It includes a description of the bits. See the following sample output:
Setting the Configuration Register While Running Cisco IOS
The configuration register can be set in the configuration mode with the config-register 0x<value>
command. See the following sample output:
Setting the Configuration Register While Running ROM Monitor
If the prompt is ">", the or0x<value> command sets the configuration register. See the following sample
output:
If the prompt is "rommon1", the confreg command sets the configuration register. It prompts the user
about each bit. See the following sample output:
Cisco 7600 Series Router Installation Guide
C-6
09 Do not use secondary bootstrap
08 Break disabled
07 OEM disabled
06 Ignore configuration disabled
05 Fast boot disabled
04 Fan boot disabled
03-00 Boot to ROM monitor
rommon 1 > confreg
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
Do you wish to change the configuration? y/n
Router# config t
Enter configuration commands, one per line. End with CNTRL/Z.
Router(config)#config-register 0x2142
Router(config)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
>o/r 0x2102
>
rommon 1 > confreg
Confiuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration y/n
enable "diagnostic mode"? y/n
enable "use net in IP bcast address"? y/n
disable "use rom after netboot fails"? y/n
enable "use all zero broadcast"? y/n
enable "break/abort has effect"? y/n
Appendix C
[n]
[n]: y
[n]: n
[n]: n
[n]: n
[n]: n
[n]: n
Configuration Register Information
OL-4503-26