Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 108

Installing the Cable Management System (Cisco 7609 Router and Cisco 7609-S Router Only)
Figure 3-18
Captive installation screws
Remove the front panel and set it aside.
Step 2
Remove the two screws that secure the cable guide to the back panel and remove the cable guide by
Step 3
lifting it up and away from the back panel. (See
Figure 3-19
Note
Step 4 Install the standard cable guide to the back panel by hooking the lip of the cable guide to the back panel.
(See Figure
Install the two screws to secure the cable guide to the back plate. (See
Step 5
Cisco 7600 Series Router Installation Guide
3-18
Removing the Front Panel
FAN
STATU S
FAN
1
FAN
2
Removing the Cable Guide
The installation of the cable guide module is shipped alongwith the chassis. The unit should slid
into the grooves on the chassis as shown in
3-19.)
Figure 3-19.)
Standard
Cable Guide
FAN
STATUS
FAN
1
FAN
2
Figure 3-19.
Chapter 3 Installing the Cisco 7600 Series Router
Figure 3-19.)
OL-4503-26