Installing The Cable Management System (Cisco 7609 Router And Cisco 7609-S Router Only) - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Chapter 3 Installing the Cisco 7600 Series Router
Figure 3-15
Tilt the chassis to the other side.
Step 3
Attach the second stabilizer bracket to the other side of the chassis with eight M4 screws.
Step 4
Step 5 Lower the chassis so that it rests on both stabilizer brackets.
Note If you are not rack-mounting the Cisco 7613 Router and you want to install the cable guide assemblies,
you must obtain ten 12x24 or 10x32 nuts. Use the screws supplied in the accessory kit and the nuts you
obtained to attach the cable guide assembly to the L bracket.
Installing the Cable Management System (Cisco 7609 Router and
Cisco 7609-S Router Only)
This section describes the installation procedures for the cable management system.
OL-4503-26

Installing the Cable Management System (Cisco 7609 Router and Cisco 7609-S Router Only)

Installing the Stabilizer Brackets
Cisco 7600 Series Router Installation Guide
3-15