Operations; Operation Flow - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
2.

OPERATIONS

When switching over the interswitch patterns, first set the system to the STBY mode and
proceed the switch operations on the operation panel of the Display Unit as shown in the
operation flow below.
2.1 Operation Flow･･････････････････････････････････････
The following flowchart shows the operation flow from menu opening to menu closing.
〔Open of software button〕
① Click the
on the upper left of the screen.
(This software button is differing in
selecting pattern. This picture is
2UNIT, No.4.)
〔Changing interswitch patterns〕
① Click the pattern selection menu number.
Click SET .
② Click EXIT .
〔Closing the interswitch menu〕
① Click EXIT .
〔The Sub1 Menu will be closed〕
① Click MENU .
〔Open of the Sub1 Menu〕
① Click MENU , then SUB1 MENU
〔The ISW Menu will appear〕
① Click ISW .
A-2
The radar will be placed in
the standby mode. The
changed pattern diagram
in the center of the display
as well as the change
menu at the right of the
display will be displayed.