Marking [Mark] - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Marking [MARK]･････････････････････････････････････････
A maximum of 20 marks can be displayed at arbitrary positions on the radar video.
A mark created on the display holds the latitude and longitude.
[I] Plotting Marks.
Procedures 1
2
3
Note: If more than 20 marks are created, the oldest mark is cleared and the newly
created mark is displayed.
[II] Clearing Marks
Procedures
1
2
3
Place the cursor over the upper right section of the screen
(right figure), then right-click. Next, select "MARK".
MARK will appear in the CURSOR （ ） at the upper left of the radar display.
Put the cross cursor mark [ + ] on the position where the [□]
mark is inserted.
Press trackball section left button.
The cross cursor mark [ + ] will be changed into the [□] mark and fixed on the
radar display. When entering more [□] marks, repeat the procedures from step
2. Up to 20 marks can be entered.
Place the cursor over the upper right section of the screen
(right figure), then right-click. Next, select "MARK".
MARK is displayed on CURSOR （ ） at the upper right of the radar display.
Put the cross cursor mark [ + ] on the position where the [□]
mark is inserted.
Press trackball section right button.
The [□] mark will disappear. When clearing another [□] mark, repeat the
procedure from step 2.
3-58
①
)
CURSOR(
CURSOR( )
３
①