JRC JMA-9922-6XA Instruction Manual page 246

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
MASTER RANGE CHG
ALREADY SELECTED
ISW END!
ISW BUSY!
MTR ST-BY!
ISW STRAIGHT
ISW STAND-BY!
ISW TIME OUT
ISW ERROR!
８
Table 8.5 List of Interswitch Alarms and Messages
Error Message
Tried to change the master range.
Selected the already selected pattern.
The switchover of the Interswitch ended normally.
Access to the ISW menu was made during interswitching.
The master MTR is in the standby mode.
Failed in straight connection when the Interswitch system stops
operating.
The Interswitch recovered normally.
Communication error occurred between interswitch and display.
The interswitch is disabled.
Note:━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
An error message and a warning are displayed at lower right (shown below) in radar
display mode.
PANEL
T 037.0 °
EBL1
EBL2 T 135.0
VRM1
VRM2
FUNC3 NAV
PIN
C
° O MENU
1.70 nm
2.20 nm No Alarm
8-15
Description
DISPLAY INFO
TOKYO
P I GZ TEST
ACK
Display position