Vector Constant - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Vector Constant･･･････････････････････････････････････････
Attention
Do not change the set value carelessly.
The vector constant shall be set to 4 normally. If the vector constant value is
higher, a target's vector will be better followed up when the target and own ship
change their course or speed, but the vector accuracy will be lower on the
Procedures
1 Click MENU on the screen. Or press OPTION2 key.
The MAIN Menu will appear.
2 Click CODE INPUT.
3 Click 0 , then END .
4 Click ARPA/AIS .
5
6 Input the new value by pressing the 0
to 8 number buttons or by using the
press END to input.
EXIT
1
2
3
The CODE INPUT Menu will appear.
The ADJUST Menu will appear.
The ARPA/AIS Menu will appear.
Click the "1. VECT CONST"edit box.
1.VECT CONST will be selected.
Click EXIT .
The ADJUST Menu will be closed.
Click EXIT .
The CODE INPUT Menu will be closed.
Click EXIT .
The MAIN Menu will be closed.
+
8-38
ADJUST
ARPA/AIS
1.VECT CONST
4
1-8
VIDEO LEVEL
3.LIMIT RING
OFF ON
EXIT
０．
or - buttons, then
８