JRC JMA-9922-6XA Instruction Manual page 158

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
[Ⅴ] Setup and Display of Geodetic System
Procedures 1
2
3
4
5
Exit
1
2
In making up any navigational information, it is necessary to set up the geodetic
system used by the connected navigation equipment. When any saved
navigational information is loaded, the geodetic system used when the
navigational information was saved will also be displayed. Then, check that the
geodetic system on display is the same as that for the connected navigation
equipment. If both geodetic systems are different, the positions of the
navigational information on radar display may be deviated. Therefore, it is
important to set the same geodetic system as the navigation equipment.
Click MENU .
The Main Menu will appear.
Click SUB1 MENU .
The Sub1 Menu will appear.
Click NAV/MAP INFO .
The NAV/MAP INFO Menu will appear.
Click GEODETIC .
4.GEODETIC will be selected.
Select by pressing
menu.
This is set by or the numeric
input dialogue box.
Select the number of geodetic
system.
(See Table of Geodetic Systems)
When the number of geodetic system is
entered, its name is changed.
Click EXIT .
The Sub1 Menu will reappear.
Click EXIT .
The Sub1 Menu will be closed.
3-86
NAV/MAP INFO
1.WPT
OFF
2.
3.
4.GEODETIC
WGS-84
in the
０．
Geodetic system name display
area:
according
system No. in the right input
area.
SUB1 MENU
ON
NAV DISP
NAV/MAP
0
EXIT
The display changes
to the geodetic
３