Radar Failure Check List - JRC JMA-9922-6XA Instruction Manual

Marine radar equipment
Hide thumbs Also See for JMA-9922-6XA:
Table of Contents

Advertisement

• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
When placing an order for repair of the product, it is requested that you could confirm the check items
and fill the results and sent the sheet to our contact.
If there is any unclear items, contact the ship on which the product is installed, and give the correct
information on the product.
Ship name:
Radar general model name: JMA-
(Write the full model name correctly)
• i 1• j
Check the following items in the order of the number, and circle the applicable answer between
YES or NO. If the item cannot be determined as YES or NO, explain in detail in the item (18),
others.
• i 2• j
If any of the items (1) to (5) if marked as NO, check the fuse of the product (refer to Section 8.2
and 8.3).
• i 3• j
Check the items (4) to (17) while the transmission (TX) in ON.
*Function mentioned in the items (14), (15) and (17) may be optional, answer is not necessary.
No.
• i 1• j
Power can be turn on. (The lamp on the operation panel is lit)
• i 2• j
A few minutes after powering-on, it will become standby status .
• i 3• j
When powering-on (or TX ON), the LCD displays something (LCD is lit).
The scanner rotates at the transmission (TX) ON.
• i 4• j
(Check the following items while transmission is ON)
• i 5• j
Current is supplied to the magnetron. (Refer to the instruction manual)
• i 6• j
Tuning is enabled. (Check with the range of 6 NM or more)
• i 7• j
Fixed marker is displayed.
• i 8• j
VRM is displayed.
While noise is displayed while set at STC and FTC minimum,
• i 9• j
GAIN maximum, IR-OFF and range 48 NM.
• i 10• j
Target reflection echo is displayed.
Sensitivity of reflection echo is normal.
• i 11• j
EBL is displayed.
• i 12• j
cursor mark moves.
• i 13• j
*• i 14• j
GYRO course can be set and normally displayed.
*• i 15• j
LOG speed can be normally displayed.
• i 16• j
ARPA works normally.
*• i 17• j
If wquipped with an interswitch, when switching from the straight mode (| |) to
(×), the failures (items marked NO) in the ablve (1) to (16), are switched over to
the other unit.
• i 18• j Others (Error message, etc.)
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ

Radar Failure Check List

Phone:
Check Item
9-2
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
Fax:
Serial No. :
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
• œ
Result
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
‚ X

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents