Automatic Setting Mode (System Start); Setting Range Scale : Range Scale; Setting Range Scale: Range Scale - JRC JMA-9922-6XA Instruction Manual

• œ • œ • œ • œ • œ • œ • œ • œ • œ
Automatic Setting Mode (System Start)¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
See sections 3.4 "Basic Operations" and 4 "Measurement of Range and Bearing" for descriptions
of operation.
Mode
DISPLAY MODE
ACQUIRE
TRIAL
GUARD ZONE
Setting Range Scale: (RANGE SCALE)¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
The ARPA functions can operate on all range scales. Usually, set the range between 1.5 to 24 NM
depENTing on the area of operation.
Attention: The ARPA acquisition range is 0.1 to 32 NM.
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ
Fig. 5-1 Mode Setting at System Start
Initial setting
RM (relative motion)
AUTO OFF
OFF
OFF
5-4
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ
Refer to Section
3.4
5.3
5.7
3.4, 5.6
• œ • œ • œ • œ • œ • œ • œ • œ • œ
‚ T