Target Acquisition; Automatic Acquisition [Auto] - JRC JMA-9922-6XA Instruction Manual

• œ • œ • œ • œ
5.4
Automatic Acquisition [AUTO]¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
‚ T
Procedures
Attention: When the Target ID No. display is set to OFF, any acquired target ship will not
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ

TARGET ACQUISITION

Attention
It is important to adjust the controls [SEA] and [GAIN] properly in the automatic
target acquisition mode to minimize the effect of sea clutter.
Target acquisition can be performed in two modes, AUTO and MANUAL, and both
modes can be used at the same time.
Attention
If untracked targets enter the guard zone when the maximum number of targets
(50 targets) is already being tracked, targets with lower levels of danger will be
cancelled and replaced.
1 Click GZ1 or GZ2 on the screen.
Automatic target acquisition will start. The target acquired will be marked with
"• ¤ " and its target ID No., which will move with the target. Its vector will appear
within one minute.
be given a target ID No.
• œ • œ • œ • œ • œ • œ • œ • œ • œ • œ
0• ‹
-45•‹
3NM
5-9
• œ • œ • œ • œ • œ • œ • œ • œ • œ
45 • ‹
0.5NM
• œ • œ • œ • œ • œ