Set Floating Ebl - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Set Floating EBL･････････････････････････････････････････
To offset the starting point of EBL1 during its operation:
Click the right figure C.
・Use the trackball to move the starting point of "EBL1".
・The starting point can be fixed by clicking the left trackball button.
When adjusting from the menu,
３
[Ⅰ] Click MENU .
The Main Menu will appear.
Click "5.EBL1".
"OFFSET"in"5.EBL1"will be set.
Move the starting point of EBL1 with the trackball.
Click the trackball section left button to fix the starting point
of EBL1.
To reset the starting point of EBL1 to the center of the radar
display.
Click "5.EBL1".
"CENTER"in"5.EBL1"will be set.
Click 0.EBL .
The Main Menu will be closed.
[Ⅱ] C ontinue to press
Continue to press
Continue to press
Note:For OFFSET of the EBL's starting point, it is possible to determine whether the
starting point is fixed at specific latitude and longitude.
EBL1 T0370°C
also allow you to set the starting point of EBL1.
.
"OFFSET"in"5.EBL1"will be set.
.
"CENTER"in"5.EBL1"will be set.
3-43
MAIN MENU
1.IR
OFF ON
2.TUNE
ON
OFF
3.PROCESS
2.PROC1
4.FUNCTION
1.FUNC OFF
5.EBL1
CENTER OFFSET
6.EBL2
CENTER
OFFSET
7. DATA OFF
8. SUB1 MENU
CODE INPUT
9.
EXIT
０．