Acquire And Measurement Data; End The Operation And Stop The System - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Acquire and Measurement Data･･･････････････････････････
For detailed operations for data acquisition and measurement, refer to Section 3.4 "BASIC
OPERATIONS" and Section 4 "MEASUREMENT OF RANGE AND BEARING".
End the Operation and Stop the System････････････････････
Exit
1
2
Note: When "PWR" is lit, data is being written to internal memory, so do not
open the shipboard breaker.
Also, when turning on the power supply again, be sure that the green
PWR switch lamp is off before pressing "PWR".
TX
Press .
STBY
The radar transmission will end and the scanner will stop rotating.
The indication TRANSMIT will be changed to STANDBY .
Maintain the "STANDBY" mode if radar observation is restarted in a
relatively short time. Observation can be restarted simply by pressing
the [TX/STBY] switch..
POWER
Press .
The power will be turned off. Orange lamp Off →
3-8
３
POWER