Display Processed Videos - JRC JMA-9922-6XA Instruction Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Display Processed Videos････････････････････････････････
Unnecessary noise will be reduced to highlight targets.
３
Procedures
○ When setting from the menu:
Attention
In watching a radar beacon mark, SART signal or a fast moving target on the
radar display, set the system to : PROCESS OFF (Processed Video OFF).
It is most suitable to use this function in the TM mode.
In using this function in the RM mode, use it in the NORTH UP or COURSE UP
mode. In using the function in the HEAD UP mode, the video may be blurred.
Clicking "PROC" on the screen will change the setting.
1 Click MENU .
The Main Menu will appear.
2 Click the setting section of
"3.PROCESS".
3.PROCESS will be selected and the
pull-down menu will appear.
3 Click a setting from 1 to 4.
3-1 When "2.PROC1" is selected.
2.PROC1 will be set and the targets moving
at high speeds will be selected.
The targets moving at low speeds will be
darkened.
This function is recommendable on the radar
ranges of 1.5 NM or less.
3-2 When "3.PROC2" is selected.
3.PROC2 will be set.
This processing speed is in a range between PROC1 and PROC3.
3-3 When"4.PROC3" is selected.
4.PROC3 will be set and the targets moving at low speeds will be selected.
The targets moving at high speeds will be darkened.
This function is recommendable on the radar ranges of 3 NM
or more.
1.IR
2.TGT ENH
3.PROCESS
4.FUNCTION
5.EBL1
6.EBL2
7.
8.
9.
０．
3-67
MAIN MENU
OFF
ON
ON
OFF
2.PROC1
1.OFF
2.PROC1
1.FUNC OFF
3.PROC2
4.PROC3
CENTER OFFSET
CENTER
OFFSET
DATA OFF
SUB1 MENU
DEGAUSS
EXIT