Setting And Operating Target Tracking; Acquiring Target; Automatic Acquisition (Automatic Acquisition) Mode - JRC JMR-5406-X Instruction Manual

6.5

Setting and operating target tracking

The Target Tracking function automatically tracks the acquired targets and records and displays the
course and speed of the targets as vector. Alerts can also be output based on the set collision decision
criteria (CPA and TCPA).
Memo
At power off and during preparation for transmission, tracking data records are deleted.

6.5.1 Acquiring target

The methods for acquiring targets include AUTO Acquisition (automatic acquisition) mode and ACQ
Manual (manual acquisition) mode.
Both modes can also be used concurrently.
6.5.1.1

Automatic acquisition (automatic acquisition) mode

By setting up and enabling the automatic acquisition/activation zone (AZ), targets intruding into the AZ
can automatically be acquired/tracked and at the same time, a New Target Warning (automatically
acquired target alarm) can be issued.
Memo
If manual acquisition is made in a state in which the number of targets being tracked has reached
the maximum number of targets (30, TT option is available :100), the target with the lowest danger
level among the targets that have been captured thus far automatically is erased successively.
When all the targets that are tracked are for manual acquisition and the number has reached the
maximum number of targets, no further acquisition is allowed.
[Operation procedure]
Open the New Target Warning setup screen by performing the following menu operations.
[Menu] button → Alert → New Target Warning
1
Enable the automatic acquisition/activation zone (AZ) by checking [Use AZ1] or [Use
AZ2].
Automatic acquisition/activation zone (AZ) includes AZ1 and AZ2.
To enable AZ1, check [Use AZ1].
To enable AZ2, check [Use AZ2].
Memo
For the details of [New Target Warning] dialogue box, refer to "12.3 New Target Warning
Generation Conditions".
To automatic acquisition/activation zone (AZ):
Clear the check of [Use AZ1] or [Use AZ2].
AZ can be enabled or disabled by using the [AZ] key on the operation unit also.
For the details of function assignment to the [AZ] key, refer to "13.24 Setting Key Assignment".
Section 6 Target Tracking and AIS 6-18