Slave Mode Setting (Master/Slave) - JRC JMA-5312-6HS Installation Manual

4.13
SLAVE MODE SETTING
(MASTER/SLAVE)
Place the system in the Slave mode when it is to be operated as the sub-display that displays radar echoes by
using radar signals from other radar equipment.
The input value of externally input bearing pulses can be set. The system can set 2048 pulses or 4096 pulses.
[I] Slave Mode Setting (Master/Slave)
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the installation
setting menu.
3. Select Slave for the item 2. Master/Slave in the menu.
Master
Slave
[II] Setting of Input Bearing Pulse (Input BP Count)
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the second page of
the installation setting menu.
3. Set the number of pulses for the item 1. Input BP Count in the menu.
2048
4096
All manuals and user guides at all-guides.com
2. Installation Menu
: The system operates as radar equipment while the own antenna is connected.
: The system operates as a sub-display while the signal cable of other radar
equipment is connected.
2. Installation Menu
→ 9. Next
:2048 pulses per antenna rotation
:4096 pulses per antenna rotation
4-15