Table of Contents
Advertisement
Voice Over Setup
Certain CJSM2-BT commands can be assigned to iDevice
commands. These are detailed below. Time related deflections
(nudges) of the joystick in each of the four directions (Fig 21.10).
•
Forward Short
•
Reverse Short
•
Left Short
•
Right Short
•
Forward Medium
•
Reverse Medium
•
Left Medium
•
Right Medium
•
Forward Long
•
Reverse Long
•
Left Long
•
Right Long
The timings associated with the nudges are programmable.
Refer to the Bluetooth Programming chapter for more
information.
Time related operations of two external profile .ac
switches.
The timings associated with the external switch operations
are programmable.
Refer to the Bluetooth Programming chapter for more
information, Section 21.0.
The Speed Down and Speed Up uttons.
The procedure to enable Voice Over on the iDevice and
assign commands is as follows:
• From the iDevice Settings menu, select General
Accessibility and set oice Over to On (Fig 21.31).
NOTE: The remainder of Voice Over set up is via the
R-Net PC programmer, contact your authorized dealer
for more information.
WARNING!
PC Programming must be done by trained and
qualified personnel only. Please contact your
Sunrise Medical authorized dealer.
• Set the parameter oice Over and then use the relevant
parameters to assign CJSM2-BT to iDevice commands.
• Refer to the Bluetooth Programming chapter for more
information, Section 21.0.
247555 Rev. A
Fig.21.31
94
R-Net Control System
Advertisement
Table of Contents
Need help?
Do you have a question about the Quickie R-Net Control System and is the answer not in the manual?