Adjusting Position Of Rea Headrest Or Neckrest; Adjusting Height Of Rea Headrest Or Neckrest; Adjusting Cheek Supports - Invacare Modulite User Manual

Modulite
It may be necessary to remove and modify the back
l
cushion cover in order to access the headrest mounting
holes on the back pan.
An optional shim plate is available. It may be installed
l
between the clamp assembly and the back pan to provide
additional spacing / clearance on Posture Back and Deep
Back.
The headrest clamp hardware is designed to install into existing
mounting holes in the backrest pan.
3.9.1 Adjusting Position of Rea Headrest or Neckrest
The adjustment of the position is the same for all Rea headrests and
neckrests.
5 mm Allen key
l
B
D
C
1. Loosen the screws A , B or the clamping lever C.
2. Adjust the headrest or neckrest to the required position.
3. Re-tighten screws and clamping lever.
24
A
4. Loosen the Allen screw D.
5. Slide the headrest left or right to the required position.
6. Re-tighten the Allen screw.
3.9.2 Adjusting Height of Rea Headrest or Neckrest
The adjustment of the height is the same for all Rea headrests and
neckrests.
1. Loosen hand screw A.
2. Adjust component to desired
3. Tighten hand screw.
3.9.3 Adjusting Cheek Supports
1. Push components inwards or pull components out to desired
position.
position.
1656515-G