Omron CP - PROGRAMMING MANUAL 05-2007 Programming Manual page 302

Data Movement Instructions
3-7-13 DATA COLLECT: COLL(081)
Purpose
Ladder Symbol
Variations
Applicable Program Areas
Operands
Operand Specifications
Transfers the source word (calculated by adding an offset value to the base
address) to the destination word.
COLL(081)
Bs: Source base address
Bs
Of: Offset
Of
D: Destination word
D
Variations Executed Each Cycle for ON Condition
Executed Once for Upward Differentiation
Executed Once for Downward Differentiation Not supported
Immediate Refreshing Specification
Block program areas
OK OK
Bs: Source Base Address
Specifies the source base address. The offset is added to this address to cal-
culate the source word.
Of: Offset
This value is added to the base address to calculate the source word. The off-
set can be any value from 0000 to FFFF (0 to 65,535 decimal), but Bs and
Bs+Of must be in the same data area.
15
Bs
to to
Of
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
Indirect DM addresses
in binary
Indirect DM addresses
in BCD
Constants
Data Registers
Step program areas Subroutines
OK
0
Bs
CIO 0 to CIO 6143
W0 to W511
H0 to H511
A0 to A959
T0000 to T4095
C0000 to C4095
D0 to D32767
@ D0 to @ D32767
*D0 to *D32767
--- #0000 to #FFFF
(binary) or &0 to
&65535
--- DR0 to DR15
Section 3-7
COLL(081)
@COLL(081)
Not supported
Interrupt tasks
OK
Of D
A448 to A959
---
269