Omron CP - PROGRAMMING MANUAL 05-2007 Programming Manual page 180

Sequence Control Instructions
Note
Timing Chart
Not interlocked
ON
0.00
OFF
ON
0.01
OFF
ON
100.00
OFF
Controlling Interlock Status from the CX-Programmer
An interlock can be engaged or released manually by force-resetting or force-
setting the Interlock Status Bit (specified with operand D of MILH(517) and
MILR(518)) from the CX-Programmer. The forced status of the Interlock Sta-
tus Bit has priority and overrides the interlock status calculated by program
execution.
Force-set: Releases the interlock.
OFF
MILH
n
100.00
Program section
controlled by interlock
MILC
n
Force-reset: Engages the interlock.
ON
MILH
n
100.00
Program section
controlled by interlock
MILC
n
Program operation can be switched more efficiently by using interlocks with
MILH(517) or MILR(518).
Interlocked
ON
OFF
MILR(518) interlock
DIFU(013) is not executed.
CIO 100.00 is OFF when the interlock is engaged.
If CIO 100.00 is force-set (ON), the interlock is released.
CIO 100.00 is ON when the interlock is not engaged.
If CIO 100.00 is force-reset (OFF), the interlock is engaged.
Section 3-4
Not interlocked
147