Advertisement
Linux Operating Systems
Linux operating system installation instructions are provided for both graphical
and console installation methods.
Installing Linux (Graphical Installation)
The Linux operating system installation is straightforward. Consult the operating
system's documentation for graphical installation procedures.
Installing Linux (Console Installation)
This section describes how to install a typical Linux operating system over a
serial console using the terminal emulator application. Though the instructions
pertain to a specific Linux version, they are representative of many Linux
platforms.
1. The terminal emulator application window should still be active in the
2. From the Save & Exit tab, arrow down to the Boot Override section,
| 72 |
To obtain additional information or assistance with the operating system
installation, refer to "Customer Support" on page 208 for instructions on
contacting a Viking Enterprise Solutions support representative.
CAUTION: Contact a Viking Enterprise Solutions support representative to verify the
chosen Linux operating system prior to installation.
CAUTION: Contact a Viking Enterprise Solutions support representative to verify the
chosen Linux operating system prior to installation.
BIOS and positioned at the Save & Exit tab. If the terminal emulator
application is not currently running, reestablish a connection and follow
the instructions provided for "Accessing the BIOS" on page 64.
Refer to "Establishing Server Console Access" on page 61 for instructions on
installation and setup of the terminal emulation program.
NOTE: Connect a USB keyboard directly to the server's USB port to simplify setup.
Some of the keystrokes, such as Ctrl+Alt+Delete, are easier to enter using an external
keyboard rather than the terminal emulation program.
and then select the appropriate USB drive or CD-ROM containing the
preloaded Linux operating system image.
NOTE: The characters typed do not display in the terminal emulation window;
however, the operating system's installer program still recognizes and responds to
them. If the installer program does not respond, press the <space bar> before the
console line when typing the command.
Chapter 6: Operating System & Firmware Setup
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
