Advertisement
3. Perform one of the following two actions:
4. The server module powers off.
USING THE BMC WEBUI
A user may control power using the BMC WebUI. Accessing the BMC WebUI
requires a virtual video connection, the BMC IP address, and a web browser.
The information contained in each screen capture in this section is for illustrative
purposes only and may vary depending on the BMC version, web browser,
system, and chosen configuration in use.
1. Point a web browser (e.g. Internet Explorer®, Firefox®, etc.) to:
Replace the
"BMC-IP-Address"
using the actual
address for the
BMC IP.
2. The BMC WebUI login screen displays as shown in Figure 5.4.
Figure 5.4 BMC WebUI login
CTC-DOC-002293, Rev A.2
CAUTION: Viking Enterprise Solutions recommends shutting the server down
gracefully, allowing the operating system to perform normal shutdown actions. Shutting
down the server without proper software intervention may cause damage to the
operating system.
a. Press and hold the power button momentarily and then release it to
initiate normal shutdown actions. This is the desired method.
b. Press and hold the power button for four seconds to immediately
power off the server without software intervention.
NOTE: To access the BMC WebUI, a virtual video connection, knowledge of the BMC
IP address, and a web browser are required.
For detailed instructions on setting up a video connection and obtaining the
server's BMC IP address, refer to the section titled "Establishing a Serial
Console Connection" on page 62 of Chapter 6.
https://<BMC-IP-Address>
VSS2249RQ Storage Server User Guide
| 57 |
Advertisement
Chapters
