Advertisement
4. Remove the cables from their corresponding connectors on the server
5. Loosen the thumbscrew on the top right corner of the server module.
Figure 8.21 Server module thumbscrew and lock bar
6. Pull the lock bar downward to release the cam from the locked position.
7. With one hand supporting the bottom of the module, grab the lock bar
8. Become familiar with the server module connectors. The connectors
CTC-DOC-002293, Rev A.2
module operator panel. Label all cables to ensure that each cable is
reinstalled in the correct port when service is completed.
The thumbscrew location is pictured in Figure 8.21.
Lock bar
The lock bar motion is demonstrated in Figure 8.21.
and pull the server module out of the enclosure.
ESD-SENSITIVE DEVICE. Only install the device on a properly grounded electrostatic
discharge (ESD) protection surface to avoid damage to the components. Always utilize
a properly grounded ESD wrist strap or mat during operation or installation of the
device, or when connecting the cables.
WARNING: Install the server module in the correct orientation. Ensure the connector
pins in the storage enclosure are straight and ready to align into the connector holes in
the server module. Never force the module into the enclosure. If a pin or data
connector is damaged, return the system for service. Do NOT attempt to straighten
pins as this can cause further damage to the enclosure.
must align properly so that the module smoothly inserts into the I/O
option slot on the rear of the enclosure. Refer to Figure 8.22 on page 112
for a close-up view of the server module connectors.
VSS2249RQ Storage Server User Guide
Thumbscrew
| 111 |
Advertisement
Chapters
