Advertisement
Releasing the CMA
Releasing the appropriate side of the CMA is necessary when performing a hot
aisle service action in order to access the PMs and server modules.
Releasing the CMA - Body Side
Figure 8.6 provides a close-up of the outside of the CMA body release button,
and identifies the CMA body connector and the CMA body rail connector
referenced in this procedure.
Figure 8.6 CMA body side components
| 98 |
NOTE: The photographs showing overall views of the CMA in this chapter show the
CMA mounted in a test rack and are for purposes of illustration only. They are not
intended to represent the CMA in an actual VSS2249RQ configuration.
NOTE: The photographs illustrating the following procedures show the CMA body
connector on the left side of the enclosure and the CMA arm connectors on the right
side of the enclosure as seen from the hot aisle. As noted in Chapter 4, "Installing the
Enclosure Into a Rack," that begins on page 27 of this User Guide, the CMA may also
be installed with the body connector on the right and the arm connectors on the left.
The procedures for releasing the CMA are the same in either case.
CMA body connector
CMA body release button
CMA body rail connector
To review the CMA components, refer to the section titled "Cable Management
Hardware" that begins on page 45 of Chapter 4.
Chapter 8: System Maintenance
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
