Advertisement
Figure 8.20 PSU removal
5. Using one hand to support the bottom of the PM, let go of the PM
6. Ensure the replacement PM is in the proper orientation with the PM
7. With one hand supporting the bottom of the replacement PM, insert the
8. Fully push the PM into the enclosure until the PM release tab engages
9. Test to ensure the PM is properly installed. Pull the finger handle slightly
10. Choose from one of the following steps, as appropriate:
CTC-DOC-002293, Rev A.2
release tab and pull the PM completely out of the enclosure by the finger
handle.
CAUTION: If both PMs require replacement and the second PM is operational,
complete all steps to remove and install the first PM, and then repeat all steps to
replace the second PM.
release tab at the top.
PM into the power cavity on the rear of the enclosure.
and the PM cams into place.
outward to verify the PM is locked in place. If the PM is easily removed
from the enclosure without pushing the PM release tab, remove the PM
and repeat steps 6 through 8, and then retest the installation.
NOTE: The proper orientation allows the PSU to cam into place once it is fully inserted
into the enclosure. If the PSU slides out of the enclosure easily without pressing the
release tab, check the orientation and reinsert the PSU into the slot.
VSS2249RQ Storage Server User Guide
PM release tab
Finger handle
Do NOT push the PSU tab
| 109 |
Advertisement
Chapters
