Advertisement
2. Unpack the shipping container.
3. Inspect each box for shipping damage.
4. Place all contents on an anti-static surface and proceed to verify
Shipping Container Contents
The shipping container contents may vary in both system components and
quantity based on individual customer needs. The system typically arrives with
each component preinstalled, but might require installation. The container
contents will likely include the following:
| 30 |
a. If the container is damaged, contact a Viking Enterprise Solutions
support representative for RMA instructions.
See the section titled "Contact Information" that begins on page 207 for
instructions on contacting a Viking Enterprise Solutions support representative.
b. If the container is undamaged, continue to step 2.
HEAVY OBJECT: This system weighs approximately 56.2 pounds (25.5 kilograms)
when all drives, two PMs, and two server modules are installed. (This weight does not
include the container weight.) Prevent personal injury and equipment damage. Obtain
assistance during rack installation and when sliding the system in or out of the rack.
a. Remove the rail kit and CMA boxes from the shipping container.
b. Lift the top packing from the shipping container.
c. Lift the enclosure out of the shipping container.
d. Lift the bezel box from the bottom packing, if included.
e. Lift the accessory box from the bottom packing.
a. If any of the boxes have sustained damage, contact a Viking
Enterprise Solutions support representative for RMA instructions.
See the section titled "Contact Information" that begins on page 207 for
instructions on contacting a VES support representative.
b. If the contents are not damaged, continue to step 3.
container contents.
VSS2249RQ Storage Server:
Two VSSEP1EC Server Modules
Two PMs, each containing one 1600W PSU
Six 60mm single impeller fans
Chapter 4: Installing the Enclosure Into a Rack
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
