Advertisement
3.2.h. Data deletion tool: System is delivered without an operating system.
3.3
PRODUCT INFORMATION
3.3.a. Indicative weight
3.3.b. Disassembly
| 136 |
Refer to software provider for data deletion tool.
CAUTION: This data storage product contains some plastic parts. Recycle all parts in
accordance with local regulations.
3.3.a.a. Cobalt in batteries: None
3.3.a.b. Neodymium in HDDs: HDDs not supported.
Instructions that follow assume the enclosure has been powered
down, all cables have been removed, and the enclosure is
removed from the rack.
3.3.b.a. Type: Data storage devices-Drives
3.3.b.b. Fastening techniques: Release catch
3.3.b.c. Tools required: Phillips® #1 screwdriver
If installed, pull the bezel off of the front of the enclosure. Press
the drive release catch to open the release handle. Pull the drive
out of the drive bay. Remove the screws from the drive carrier
and extract the drive. Repeat for all remaining drives. Recycle
according to local regulations.
3.3.b.a. Type: Data Storage Devices-M.2s
3.3.b.b. Fastening technique: Thumbscrew, lock bar, screws
3.3.b.c. Tools required: Phillips® #1 screwdriver
Unscrew the VSSEP1EC thumbscrew and pull the lock bar
outward and down to release the cam. Slide the VSSEP1EC out
of the enclosure. Remove the screws securing the cover on the
module and remove the cover. If installed, remove the screw
securing the PCIe face plate in the upper left PCIe slot, and then
remove the card from the riser. Unscrew the M.2 and remove.
Repeat if a second M.2 is installed. Recycle according to local
regulations.
3.3.b.a. Type: Memory
3.3.b.b. Fastening technique: Thumbscrew, lock bar, screws
3.3.b.c. Tools required: Phillips® #1 screwdriver
Appendix E: Lot 9: Annex II, 3.2 and 3.3
CTC-DOC-002293, A.2
Advertisement
Chapters
