Advertisement
4. Press the release catch on the drive carrier in the direction of the arrow
Figure 8.14 Open carrier handle
5. Lift the carrier handle fully open as shown in Figure 8.14 and gently
6. Grab the carrier frame below the release handle and pull the drive carrier
7. Place the drive carrier assembly on an anti-static surface.
8. Remove the two screws that secure the drive to the drive carrier
Figure 8.15 Drive carrier assembly screw location
9. Slide the drive toward the drive carrier handle to disengage the drive
| 104 |
to open the handle as identified in Figure 8.13 on page 103. The cam
releases from the locked position.
Carrier handle
Release latch
begin to partially remove the drive carrier from the drive bay by pulling
the middle of the handle. Use care to avoid damaging the release latch,
also identified in Figure 8.14.
assembly completely out of the drive bay.
assembly. Review Figure 8.15 for the location of the screws.
from the carrier.
CAUTION: Use care when removing and installing the drive to avoid damage to the
LED light pipe, which is exposed along the side of the drive carrier. (see Figure 8.14 on
page 104)
Chapter 8: System Maintenance
Release catch
LED light pipes
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
