Advertisement
10. Lift the drive up and away from the drive carrier.
11. Either place the existing drive in a new drive carrier, or a new drive in the
12. Slide the drive into the carrier until the connectors engage.
13. Secure the drive to the carrier using the two screws previously removed
14. Ensure the carrier handle is in the fully open position as shown in Figure
15. Grab the frame just below the carrier handle and gently push the drive
16. Press the release handle downward until the release latch (identified in
17. Ensure that the drive carrier assembly is properly installed fully inside
18. Repeat steps 4 through 17 for any remaining drives.
19. Follow the instructions provided on page 117 to complete the service
20. Drive and/or drive carrier replacement is complete.
FAN MODULES
The storage enclosure includes six fan modules. Should a fan fail, replace the
fan module as per the following instructions.
1. Complete all steps outlined in the section titled "Removing the Optional
2. Complete all steps outlined in the section titled "Enclosure Extension"
3. Lift the fan module cover on the top of the enclosure to expose the fan
CTC-DOC-002293, Rev A.2
existing drive carrier, and align the carrier connectors with those on the
bottom of the SSD.
in step 8.
CAUTION: Only torque screws to 4–6 in-lbs (.045-.068 Nm). Over-torqued screws can
damage the drive carrier.
8.14 on page 104.
carrier assembly into the drive bay until the carrier handle engages.
Figure 8.14 on page 104) connects with the release catch and the drive
carrier assembly cams into place.
the drive bay so that it is flush with the face of the enclosure.
action and return the bezel to the front of the enclosure. If no bezel is
installed, skip this step.
Bezel" that begins on page 95. If a bezel is not installed, skip this step.
that begins on page 96.
module cavity as shown in Figure 8.16.
VSS2249RQ Storage Server User Guide
| 105 |
Advertisement
Chapters
