Advertisement
1. Become familiar with each of the CMA components that are identified in
2. Verify the CMA direction. To change the direction of the CMA so that the
Figure 4.20 Switching CMA directions
3. Slide the CMA body connector (E) onto the body rail connector (F) until
4. Slide the inner CMA arm connector (A) onto the inner rail connector (B)
5. Slide the outer CMA arm connector (C) onto the outer rail connector (D)
6. Connect the cables to the appropriate ports server module operator
7. Starting with the thickest gauge cable first, run each cable through the
| 46 |
Figure 4.19 and listed in Table 4.1 on page 45.
CAUTION: If the CMA ships preinstalled, a zip tie strap will secure the CMA to the
cross bar during transportation to prevent damaging the CMA. This strap must be
removed prior to initial use. See Figure 4.21 on page 47.
body connector is on the opposite side of the enclosure, press the pivot
release button on the outside of the CMA elbow (identified in Figure
4.20), pivot the arm 180 degrees, and pivot the arm connectors 180
degrees.
the connector release button clicks.
until the connector release button clicks.
until the connector release button clicks.
panels and jacks. Do not connect the power cords to a PDU at this time.
loops on the CMA as demonstrated in Figure 4.21.
Chapter 4: Installing the Enclosure Into a Rack
Pivot release button
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
