Advertisement
Figure 8.22 Server module connectors
9. Ensure the server module lock bar is in the downward, unlocked
10. With one hand supporting the bottom of the server module, fully slide the
11. Push the module into the enclosure until the lock bar engages and the
12. Push the lock bar upward to cam the server module in place. Lock bar
13. Tighten the thumbscrew to secure the module to the enclosure. The
14. Connect all cables that were removed earlier into the appropriate ports
15. Perform the required steps to complete the service action as outlined in
16. Server module service is complete.
SERVER MODULE COIN CELL BATTERY
The VSS2249RQ Storage Server features a replaceable coin cell battery
mounted in a bracket on the server board. The following procedure assumes
that the canister lid has been removed so that the battery slot is accessible.
| 112 |
position. Refer to Figure 8.21 on page 111 to view the lock bar operation.
server module into the appropriate empty I/O option slot on the rear of
the enclosure.
module is flush with the face of the enclosure. Never force the module
into place.
operation is pictured in Figure 8.21 on page 111.
thumbscrew locations are pictured in Figure 8.21 on page 111.
on the server module operator panel.
the section titled "Returning the CMA" on page 118.
ESD-SENSITIVE DEVICE. Always use a properly grounded ESD wrist strap or mat
and non-conductive tools during removal and replacement of the battery.
CAUTION: Hot-swapping any VSSEP1EC Server Module should be completed within
five (5) minutes to maintain proper system cooling. If replacement will not completed
within five minutes, install a module blank in the empty I/O option slot. Contact a Viking
Enterprise Solutions support representative for information on obtaining a server
module blank.
Chapter 8: System Maintenance
Connectors
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
