Advertisement
Figure 8.30 Bezel installation
3. Push the bezel into the left side of the left rack ear. The stud should join
4. Bezel installation is complete.
Returning the CMA
Once service actions to the PMs or server modules are completed, return the
CMA to its operational position.
Returning the CMA - Body Side
1. Swing the CMA arm forward to the CMA body side rail.
2. Align the CMA body connector with the CMA body rail connector, as
| 118 |
Bezel left underside
Left rack ear
the retention clip inside the left side of the bezel cover.
To review the CMA components, refer to the section titled "Cable Management
Hardware" that begins on page 47 of Chapter 4.
shown in Figure 8.31 on page 119.
Chapter 8: System Maintenance
Right rack ear
CTC-DOC-002293, Rev A.2
Advertisement
Chapters
