Advertisement
Tools Required
The following tools are required to replace the coin cell battery:
•
•
See Figure 8.23 for examples.
Figure 8.23 Tools required for battery replacement
Replacing a Coin Cell Battery
The coin cell battery holder is located near the edge of the server board next to
the wall of the canister. To replace the battery follow these steps:
1. Place the prober soldering tool on the server board between the battery
CTC-DOC-002293, Rev A.2
CAUTION: The battery holder is made of plastic and can be loosened or broken if not
properly supported. Be sure to use the tools and methods specified in the procedure to
avoid damage.
Non-conductive needle-nose tweezers.
A non-conductive prober soldering tool
holder and the wall of the canister to provide support for the base of the
battery holder, as shown in Figure 8.24.
Prober Soldering Tool
Figure 8.24 Prober soldering tool in place
VSS2249RQ Storage Server User Guide
| 113 |
Advertisement
Chapters
