Paradyne 9161 Reference Manual page 208

Asynchronous Port Table
9161-A2-GH30-20
The Asynchronous Port Table contains an entry for the COM port when the port is
configured for asynchronous operation. The Asynchronous Port Table is not
supported for the synchronous data ports. This object is supported for the COM
port only. For this unit, entries in the table that are counters (rs232AsyncPortEntry
6–8) are used to collect statistics only and are not supported. Clarification for
objects contained in this table as it applies to the unit is provided below.
Object Description
rs232AsyncPort Specifies the number of bits
Bits in a character.
(rs232Async
PortEntry 2 )
rs232AsyncPort Specifies the number of
StopBits stop bits supported.
(rs232Async
PortEntry 3 )
rs232AsyncPort Specifies the type of parity
Parity used by the port.
(rs232Async
PortEntry 4 )
rs232AsyncPort Specifies the ability to
AutoBaud automatically sense the
(rs232Async input speed of the port.
PortEntry 5 )
September 1997
MIB Descriptions
Setting/Contents
Supports only the following values:
7 – 7-bit characters. Only use when
Port Use is set to Alarm.
8 – 8-bit characters
Supports only the following values:
one(1) – One stop bit
two(2) – Two stop bits
one-and-half(3) – One and a half
stop bits
Supports only the following values:
none(1) – No parity bit
odd2) – Odd parity
even(3) – Even parity
Supports only the following value:
disabled(2) – Does not support
Autobaud
B-27