Trap: Authentificationfailure; Traps: Linkup And Linkdown - Paradyne 9161 Reference Manual

SNMP Traps

Trap: authentificationFailure

Traps: linkUp and linkDown

C-2
Trap What It Indicates
authenticationFailure Access to the T1 access
unit was attempted and
failed.
Trap What It Indicates
linkDown The link is down.
linkUp The link is operational.
The interfaces that support these traps and conditions that define linkUp and
linkDown for each interface:
linkUp/Down
Interface
Variable-Bindings
PHYSICAL SUBLAYER – Represented by the entry in the MIB II Interfaces Table.
Network and DSX-1
interfaces
(Supported by the
DS1 MIB.)
September 1997
ifIndex (RFC 1573)
ifAdminStatus
(RFC 1573)
ifOperStatus (RFC 1573)
i
fType (RFC 1573)
dsx1LineStatus
(RFC 1406)
Possible Cause
SNMP protocol message not
properly authenticated.
Three unsuccessful attempts
were made to enter a correct
login/password combination.
IP address security is
enabled, and a message was
received from SNMP Manager
whose address was not on the
list of approved managers.
Possible Cause
A failure in one of the
communication interfaces has
occurred.
One of the failed communication
interfaces is up and operational.
Possible Cause
linkDown – One or more
alarm conditions are active on
the interface.
Alarm conditions include:
– Loss of Signal (LOS)
– Out of Frame (OOF)
– Alarm Indication Signal
(AIS)
– Excessive Error Rate (EER)
– Yellow Alarm
linkUp – No alarms on the
interface.
9161-A2-GH30-20