Paradyne 9161 Reference Manual page 209

MIB Descriptions
Synchronous Port Table
B-28
The Synchronous Port Table contains an entry for each of the synchronous data
ports and the COM port when the port is configured for synchronous operation.
For this unit, entries in the table that are counters (rs232SyncPortEntry 3–7) are
used to collect statistics only and are not supported. Clarification for objects
contained in this table as it applies to the unit is provided below.
Object Description
rs232SyncPort Specifies the clock source
ClockSource for the port.
(rs232Sync
PortEntry 2 )
rs232SyncPort Specifies whether this
Role device interface is a DTE or
(rs232Sync DCE.
PortEntry 8 )
rs232SyncPort Specifies the bit encoding
Encoding technique that this port
(rs232Sync uses.
PortEntry 9 )
rs232SyncPort Specifies the method used
RTSControl to control the RTS signal.
(rs232Sync
For synchronous data
PortEntry 10 )
ports, this corresponds to
Send All Ones on Data Port
Not Ready configuration
option, except that Both
and DTR cannot be
represented.
rs232SyncPort Specifies the interval (in
RTSCTSDelay milliseconds) that the DTE
(rs232Sync
must wait after RTS is
PortEntry 11 )
asserted before it can
assert CTS.
rs232SyncPort Specifies the port's mode of
Mode operation with respect to
(rs232Sync the direction and
PortEntry 12 ) simultaneousness of the
data transfer.
rs232SyncPort Specifies the minimum
MinFlags number of flag patterns the
(rs232Sync port needs to recognize the
PortEntry 14 ) end of one frame and the
start of another.
September 1997
Setting/Contents
Supports only the following values:
internal(1) – The port uses an
internal clock.
external(2) – The port uses an
external clock.
Supports only the following value:
dce(2) – The port acts as a DCE.
Supports only the following values:
nrz(1) – The port uses non-return to
zero encoding.
nrzi(2) – The port uses non-return to
zero inverted encoding. Corresponds
to when the transmit and received
data are inverted.
Supports only the following values:
controlled(1) – For user data ports,
this value is used when the port is
configured for RTS or Both. Setting
this value is equivalent to configuring
the port for RTS.
constant(2) – For user data ports,
this value is used when the port is
configured for DTR or None. Setting
this value is equivalent to configuring
the port to None. This is the only valid
value for the COM port.
Supports only the following value:
0 – The port does not have to wait.
Supports only the following value:
fdx – The port is full duplex.
Supports only the following value:
2 – The minimum number of flags
supported for all ports on the unit.
9161-A2-GH30-20