IBM 3745 Problem Determination Manual page 189

Host Messages
You may be concerned
by a usage tier problem:
If
1. For 3745 models 130, 150, 160, or
170 you use NCP V5R2.1 or later.
2. For 3745 models 210, 310,410, or
610 you use NCP V5R 1 or later.
An NCP command (ACTLlNK) to activate
a link is rejected with an NCP exception
response.
(sense code X'0801 0006')
This may be due to a line that is
associated with a line adapter not valid
for the usage tier generated in the NCP.
Do
Go to:
1. Table 2-1 on page 2-5.
2. Table 2-2 on page 2-7.
to determine which adapter positions
are allowed by a particular usage tier.
Check if you meet the following usage
tier rules:
• The tiers are based only on the
physical positions of the adapters.
Refer to Table 2-1 on page 2-5 and
Table 2-2 on page 2-7 to determine
adapter positions allowed by a
particular usage tier.
• An upgrade of the 3745 hardware
must be followed by a change of the
usage tier level.
When upgrading both hardware and
software on models 130, 150, 160, or
170, the software must be upgraded
first.
• If not available:
CO
2-4
IBM 3745 Communication Controller: Problem Determination Guide"
0 , \
,I ..•
,1".
c"