Table of Contents
Advertisement
SAM BOOST™ WITH SMART NOZZLE N
If the user holds the manual mode button on the valve control page, then the valve will enter manual
override mode. In this state, there is no automatic pressure regulation. The valve will stay stationary at the
position it is in until changed by the operator. The valve screen pages will show the valves desired set
position. The valve desired position can be adjusted using the up/down arrows on the valve control page.
Holding the manual mode button again will put the valve back into an automatic control state. Closing the
valve and power cycling the system will also return the valve to automatic control state
6.2.7
System Shut Down
When you are ready to shut the system down perform the following:
1. Close all discharge valves by going to the valve page and selecting the red close line button (shown
above)
2. Idle the truck by selecting the idle button.
3. Follow your jurisdiction's SOP to take the truck out of pump gear
•
Note that this will automatically close the tank to pump
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Page: 44 of 66
Advertisement
Table of Contents
