Table of Contents
Advertisement
SAM BOOST™ WITH SMART NOZZLE N
□
Unplug and remove original equipment pressure governor
•
Leave governor harness installed as it will connect to SAM Boost™ harness
□
Mount SAM Boost™ display with adapter plate
□
Connect all harnesses shown on system layout drawing (FSG-PL-01530)
□
Plug original governor harness into SAM Boost™ harness
If buzzer included in kit:
□
Remove original equipment buzzer
□
Install SAM Boost™ display buzzer
If starting from a new panel, the following figure shows cutout information required for installing the display.
5.7.2
WARNING LABEL & COVER PLACARD INSTALLATION
While using a SAM Smart Nozzle, the following warning labels have been included and must be installed for
safety concerns while operating preconnected hoses. Locate and place the label on the truck where the Smart
Nozzle hoses will be stored and deployed.
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Page: 28 of 66
Advertisement
Table of Contents
