Table of Contents
Advertisement
SAM BOOST™ WITH SMART NOZZLE N
9.3.2
Akron Valve Pressure Calibration
It is recommended to calibrate the pressure transducers annually. Please follow the steps in the "Pressure
Calibration Password" Section of this manual to calibrate sensors.
If the sensor is ever not performing appropriately, then remove sensor, inspect sensor and line for debris.
Clean out as needed.
This calibration will also calibrate the Master intake and discharge pressure transducers.
9.4
Pump Vent Solenoid Maintenance
Check Pump Vent Solenoid Strainer
It is recommended to check the pencil strainer located on the pump vent solenoid annually. Follow the
steps below:
1. Locate pump vent solenoid on discharge side of pump
2. Remove pump vent solenoid.
3. Inspect pencil strainer
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
Action
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Cadence
Annually
Page: 63 of 66
Advertisement
Table of Contents
