Fcc Notices; Ised Notice (English & French) - Idex Akron Bras SAM BOOST Operation Installation Maintenance Manual

For sam boost with smart nozzle n2p and uv780 display
Table of Contents

Advertisement

SAM BOOST™ WITH SMART NOZZLE N
o
FCC ID: 2AC7Z-ESPWROOM02D
o
21098-ESPWROOM02D
IC ID:
o
Protocol 802.11 b/g/n
o
Operational range: 10 feet (3.048 m)
Environmental Conditions:
o
Operating Temperature: -20 °C (-4 °F) to 60 °C (140
o
Storage Temperature: -10 °C (14 °F) to 30 °C (86 °F) Batteries; -20 °C (-4 °F) to 60 °C (140
°F) SAM™ SMART NOZZLE
o
Power management: Automatic shutdown and sleep mode
o
Ingress protection: IP67 equivalent

12.1 FCC NOTICES

Change or modifications that are not expressly approved by the manufacturer could void the user's authority
to operate the equipment. (Per FCC Part 15.21)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. (Per FCC Part 15.19)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures as applicable (Per FCC Part 15.105):
Reorient or relocate the antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into a circuit different from that to which the receiver is connected.
Consult the dealer or the factory for assistance.
12.2 ISED NOTICE (ENGLISH & FRENCH)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
(Per RSS-Gen Section 8.4)
Cet appareil contient un ou des émetteurs/récepteurs exempts de licence conformes aux RSS exempts de
licence d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux
deux conditions suivantes:
1. Cet appareil ne doit pas causer d'interférences.
2. Cet appareil doit accepter toutes les interférences, y compris les interférences pouvant entraîner un
fonctionnement indésirable de l'appareil.
(Selon RSS-Gen Section 8.4)
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
°F).
Page: 66 of 66

Advertisement

Table of Contents
loading

Table of Contents