Table of Contents
Advertisement
SAM BOOST™ WITH SMART NOZZLE N
5.3
ANTENNA INSTALLATION
See plate drawing 546-00119-000 for radio module and antenna installation drawing.
The antenna provided with the system includes an 8' length coaxial cable that connects to the radio module.
This cable cannot be extended so plan a proper installation location. Follow the steps below for antenna
installation:
□
Locate desired antenna location
•
The antenna should be located such that it clears the top of the cab and truck body, but away
from any components that might interfere.
•
If antenna is on any surface that can tilt or move (for example tilt cab), verify there is sufficient
wire length to allow for this movement. Failure to account for this may damage the cable or
other components when surface moves.
•
Antenna should be centered to provide equal coverage to all areas. See the examples below.
These show how biasing the antenna to one side/corner of the truck can cause uneven nozzle
range.
□
Mount the Antenna using the two provided #8 screws .
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Page: 20 of 66
Advertisement
Table of Contents
